We have High Pressure Oil Pressure Gauges made specifically for the 6.0 Powerstroke & 7.3 Powerstroke that monitor high pressure entering your Ford truck diesel engine’s pumps with pinpoint accuracy. These gauges help you detect weak or defective HPOP which could starve the injectors for fuel and lead to other system failures.

If you’re looking for a quick and easy way to get this gauge installed we also stock an HPOP Gauge Wiring Harness that cuts down on installation time. You won’t have to splice any factory wiring or make any other modifications.

This pigtail harness installs directly to the injector control pressure sensor (ICP) for a clean and effortless installation. All you have to do is disconnect the ICP sensor harness connector and plug the harness into the ICP sensor and sensor harness. Connect the green and black wires from the gauge harness to the matching wires and you’re good to go.

When we measured out the wiring, we made sure you had added length for more flexibility during the install. Each high pressure oil pressure gauge harness is 9” long with 11” sensor and ground lead wires. That way you can get the right setup when you run the connections.

If you have a 6.0 or 7.3 Powerstroke and you’re looking to add an HPOP gauge, we’ll save you time and effort with our High Pressure Oil Pressure Gauge Pigtail Wiring Harness. Your gauge will be set up in no time so you can make sure high pressure levels are where they should be.